Step 1  The design of your curbing is planned out and then sprayed on the ground to ensure that the proposed layout is exactly what you want.

Step 2  A grass cutter is used to remove the existing grass and to redefine the existing or new layout of the landscape bed. The ground is then leveled and tamped to make sure your curbing will be level and have a solid base to be layed on.

Step 3  All of the concrete for your job will be mixed on site using the highest quality materials available. By mixing all of the concrete on site we can control all of the ingredients to ensure the best mix for the job.

Step 4 The mix is then wheeled to the curbing machine and extruded onto the prepared areas. The curb is then hand troweled to a smooth finish. Texturing and stamping are done at this point if desired.

Step 5  Expansion joints are cut into the curb every four feet to ensure proper curing and to allow the concrete to expand and contract evenly.

Step 6  Excess concrete and materials are cleaned up and the jobsite site is left as clean as it was when we arrived.

Design Layout

Grass Removal

Curbing Machine